Trane Relay Panel Wiring Diagram
RGF REME HALO Light-emitting diode Installation
Call to order 910-401-3910
The following instructions are recommended installation instructions of the REME Gloriol Light-emitting diode for HVAC Contractors from the Manufacturer:
CALL OR Electronic mail for Pricing and Availability
"When using the Halo LED on a newer HVAC whole utilizing a versatile speed fan or ramping motor with constant on 24-volt control, it is recommended the enclosed relay or exchangeable (24VAC coil, SPDT) be used in govern to tour off the power to the HALO LED when the HVAC unit is turned on and off. Unlike the standard Halo, the longest life for the LED Halo is achieved with it cycling on and off PR.
Note: This is only a recommended installation for the control electrical relay, all wiring must be done to comply with all pertinent local codes and regulations. To avoid harm or scandalise hazard, ascertain powerfulness is unconnected from the HVAC building block prior to any electrical put to work being performed."
Notice to Installer: This unit must be wired in series with the blower to cycle happening/off with the blower. This installation is required in order to equal in conformity with new safety standards and to see to it maximum energy efficiency and LED module armed service life.
- Attach the relay to the Actinium control panel in a suited localization inside the enclosure.
- Install ¼" UL approved egg-producing spade connectors, piggyback spade connectors may be required for some connections, (connectors not provided), on the pursual as per the wiring diagram to a lower place:
- AHU Line 1
- Transformer Contraband wire
- Heating sequencer relay output Tune 1
- Yellow wire from AHU Condenser Contactor-Power
- Condenser Common/ TStat Common
- Connect the wires above to the relay per the wiring diagram, Design 1.
- Connect the wires from the HALO-LED to the supplied transformer per See 1.
- Connect AHU Assembly line 2 to the supplied transformer reported to the unit voltage.
IMPORTANT NOTICE TO INSTALLERS
REME-Ring-LED Installation – Air Sensing Switch (RGF share # HLED-AS)
1. The Halo-LED cannot personify wired flat to the EAC terminal, doing so will damage the unit and void the warranty.
2. For gas heat units with a cap start, 2 speed blower the unit can be wired with the provided relay arsenic described in the manual, with the exception that TERMINAL 5 must be jumped to the crushed speed fan fire u terminal on the fan control board.
3. Gasoline heat units with a variable travel rapidly fan motorial mustiness use the optional aviation sensing kit (RGF part #HLED-AS), available at your local distributer. For installation differently those discussed in the provided installation manual, the optional air perception kit (HLED-AS) mustiness be used. The optional strain sensing kit can be used for all installations, without exception.
This theatrical role is available to order through RGF using part # HLED-Arsenic. We ask that you part this information with your installers and urge that you stock this token as required.
REME HALO LED for Home Air Refinement
Get on thelist to be notified when REME HALO is back in stock.
See a comparison between the REME HALO and the REME Nimbus Light-emitting diode
The REME Glory UV light model REME-H is in stock and available purchasable now.
REME Gloriol LED Wiring Plot
Source: https://atomicfilters.com/blogs/news/rgf-reme-halo-led-installation-wiring-diagram-for-contractors
Posted by: vaniavelk.blogspot.com
Comments
Post a Comment